![]() Randomization during Wi-Fi scanning is enabled by default starting on version 1.2.0, and it can be disabled by adding the following lines to /etc/NetworkManager/NetworkManager. You can run the following to show all interfaces that are up and what IP addresses they have been. Both modes can be configured by modifying /etc/NetworkManager/nf An older but still useful command is the ifconfig command. There is some useful information about MAC address randomization during Wi-Fi scanning on the ArchWiki:Īs of version 1.4.0, NetworkManager supports two types MAC Address Randomization: randomization during scanning, and stable randomization. To disable this, you may edit your /etc/NetworkManager/nf as follows: NetworkManager will reset your MAC address during Wi-Fi scanning. To permanently change your MAC address, append the following line to your /etc/network/interfaces: pre-up ifconfig hw ether xx:xx:xx:yy:yy:yy But at the end of the day, they are also only wrappers for executing ip link set and macchanger. You could also do it using systemd units as explained here: Changing mac using systemd units. Udev method - Create the file etc/udev/rules.d/les with the following content: ACTION="add", SUBSYSTEM="net", ATTR="XX:XX:XX:XX:XX:XX", RUN+="/usr/bin/ip link set dev %k address YY:YY:YY:YY:YY:YY" ![]() However, if you are having problemas while changing mac through network/interfaces you could do it through udev Related stuff: Good detailed explanation of /etc/network/interfaces syntax? Example: auto enp3s0Ī detail that i have missed: The hwaddress configuration item needs to be after the gateway stanza, if you are setting a static ip address. Use the hwaddress ether inside your interface configuration block. I have been looking at tutorials online though I can't seem to get stuff right, and my computer even started acting very strangely a few times afterwards. I would like to change the mac address of all of my interfaces (enp3s0, wlp2s0) (lo is loopback so no need there), but I am unfamiliar with the commands in the /etc/network/interfaces file. I get the following output # interfaces(5) file used by ifup(8) and ifdown(8)Īnd when I do ifconfig on my ubuntu, I get back 3 different interfaces: Now when I use the following code: cat /etc/network/interfaces Stanza, e.g., right after the gateway line) so that the MAC address is On Debian, Ubuntu, and similar systems, place the following in theĪppropriate section of /etc/network/interfaces (within an iface So I found this great article online explaining how to change a Mac Address permanently through the /etc/network/interfaces file on my Ubuntu. ![]() ![]() Every so often I will get the latest changes from the SF svn repo using “git-svn rebase”.How might I be able to specifically change the Mac Address of the enp3s0 and wlp2s0 interfaces through the /etc/network/interfaces file? What code would I have to include inside? I have been trying for some time now without success sadly enough. ![]() When I code and test, I work with the local git repo and push changes to the bitbucket repo. The last thing I do is “git push -u origin master” & “git-svn rebase”. I first clone from SF svn using git-svn, then add bitbucket repo as a remote, then push files from local git repo to bitbucket. Sourceforge (SF) svn -> local git -> git Just the normal svn or download install method. You shouldn’t have any issue updating though. I could use git-svn but I don’t feel comfortable doing commit’s and the like through my git repo. I actually hand mash out the code lines based on your repo, or if there were significant changes (too much for me to accurately type out) I copy the files in place using wget. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |